J&J Amusements Bumper Boat 2014 Service Manual page 122

3-34
GEARBOX AND DRIVE SHAFT
503-304-8899
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com
Next, remove the gasket and discard, as this item will be re-
NOTICE: The keyway is welded in place on both ends of the
drive shaft. If the keyway is damaged or worn, the drive shaft
Lower the shaft into the housing. When the shaft contacts the
Coat both sides of the new gasket with a thin coating of sili-
Visit www.Jjamusements.Com and download a
copy of our complete accessory catalog!
placed with a new gasket. (J&J #01981).
Grasp the end of the shaft and remove.
The drive shaft can be installed in either direction.
Before installing the shaft, coat both ends with MARINERS
motor output shaft, rotate the shaft in order to align the
motor shaft slot and the drive shaft keyway; you will
feel the drive shaft move toward the motor when this
Make sure to align the key slot on the gearbox shaft with
Remove the gearbox assembly.
must be replaced.
CHOICE NEVER SEEZ®.
sealant and install on the housing.
the keyway on the drive shaft.
Tighten the mounting bolts.
occurs.
cone