Others Set Mode - Icom IC-7600 Instruction Manual

Others set mode

Calibration Marker
This item is used for a simple frequency check of the
transceiver. (default: OFF)
See p. 147 for calibration procedure.
NOTE: Turn the calibration marker OFF after
checking the frequency of the transceiver.
Beep (Confirmation)
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent
operation. (default: ON)
The beep output level can be set in level set mode.
(p. 123)
Beep (Band Edge)
A beep sounds when an operating frequency enters
or exits an amateur band. This functions indepen-
dent of the confirmation beep setting (above).
The beep output level can be set in level set mode.
(p. 123)
When "ON (User)" or "ON (User) & TX Limit" is
selected, [BAND] appears in the display above the
function switch (F-5), and up to 30 band edge fre-
quencies can be set in band edge screen.
Beep Sound
Sets the desired beep frequency within 500 to
2000 Hz in 10 Hz steps. (default: 1000 Hz)
RF/SQL Control
The [RF/SQL] control can be set as the RF/squelch
control (default), the squelch control only (RF gain
is fixed at maximum) or 'Auto' (RF gain control in
SSB, CW, RTTY and PSK; squelch control in AM
and FM).
See pgs. 2, 33 for details.
Quick Dualwatch
When this item is set to ON, pushing and holding
[DUALWATCH] for 1 sec. sets the sub readout fre-
quency to the main readout
dualwatch operation. (default: ON)
frequency, and activates
OFF
• OFF : Calibration marker OFF
• ON : Calibration marker ON
ON
• OFF : Confirmation beep OFF
• ON : Confirmation beep ON
ON (Default)
• OFF : Band edge beep OFF
• ON (Default) : Band edge beep sounds when an
operating frequency enters or exits a
default amateur band. (default)
• ON (User) : A beep sounds when an operating
frequency enters or exits an ama-
teur band that is set in band edge
screen. (p. 31)
• ON (User) & TX Limit
: A beep sounds when an operating
frequency enters or exits an amateur
band that is set in band edge screen
and TX is limited out of the band.
(p. 31)
1000Hz
RF+SQL
• AUTO : [RF/SQL] control as RF gain control
in SSB, CW, RTTY and PSK; squelch
control in AM and FM
• SQL : [RF/SQL] control as squelch control
• RF+SQL : [RF/SQL] control as RF/squelch control
(default)
ON
• OFF : Quick dualwatch OFF
• ON : Quick dualwatch ON
10
SET MODE
Continues to the next page.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
128