Others Set Mode - Icom IC-7700 Instruction Manual

12
SET MODE

■ Others set mode

Calibration Marker
This item is used for a simple frequency check of the
transceiver. (default: OFF)
See p. 13-5 for calibration procedure.
NOTE: Turn the calibration marker OFF after
checking the frequency of the transceiver.
Beep (Confirmation)
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration. (default: ON)
The beep output level can be set in level set mode.
(p. 12-6)
Beep (Band Edge)
A beep sounds when an operating frequency enters
or exits an amateur band. This functions independent
of the confirmation beep setting (above). (default: ON)
The beep output level can be set in level set mode.
(p. 12-6)
Beep Sound
Sets the desired key-touch beep frequency within 500
to 2000 Hz in 10 Hz steps. (default: 1000 Hz)
Quick SPLIT
When this item is set to ON, pushing and holding
for 1 sec. sets the unselected VFO's readout
SPLIT
frequency to the selected VFO's readout frequency
and activates split operation.
(default: ON)
See p. 6-7 for details.
OFF
ON
ON
1000Hz
ON
12-12