Miscellaneous (Others) Set Mode - Icom IC-7800 Instruction Manual

12
SET MODE

■ Miscellaneous (Others) set mode

This item is used for a simple frequency check of the
transceiver. (default: OFF)
See p. 13-5 for calibration procedure.
NOTE: Turn the calibration marker OFF after
checking the frequency of the transceiver.
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration. (default: ON)
The beep output level can be set in level set mode.
(p. 12-5)
When you tune into or out of an amateur band's fre-
quency range, a beep sounds. This functions inde-
pendently of the confirmation beep setting.
The beep output level can be set in level set mode.
(p. 12-5)
When "ON (User)" or "ON (User) & TX Limit" is se-
lected, [BAND] appears in the display above the func-
tion switch (F-5). Up to 30 band edge frequencies can
be programmed in the band edge screen.
(see the page 3-14 for programming details.)
Sets the desired key-touch beep sound frequency
during main readout operation within 500 to 2000 Hz
in 10 Hz steps. (default: 1000 Hz)
Set the different frequency from "Beep Sound (SUB)"
as below to distinguish between main and sub.
Sets the desired key-touch beep sound frequency
during sub readout operation within 500 to 2000 Hz
in 10 Hz steps. (default: 1000 Hz)
Set the different frequency from "Beep Sound (MAIN)"
as above to distinguish between main and sub.
• OFF
• ON (Default) : When you tune into or out of
• ON (User)
• ON (User) & TX Limit
12-14
: Band edge beep is OFF.
the default amateur band's fre-
quency range, a beep sounds.
(default)
: When you tune outside of, or
back into a user programmed
amateur band's frequency range,
a beep sounds.
: When you tune outside of, or
back into a user programmed
amateur band's frequency range,
a beep sounds. Transmission is
also inhibited outside the pro-
grammed band.