Memory Channel Programming; D Programming In Vfo Mode; D Programming In Memory Mode - Icom IC-7600 Instruction Manual

6
MEMORY OPERATION

Memory channel programming

Memory channel programming can be preformed
either in VFO mode or in memory mode.

D Programming in VFO mode

q Set the desired frequency, operating mode and fil-
ter width in VFO mode.
w Push [∫]/[√] several times to select the desired
memory channel.
• Memory list screen is convenient for selecting the
desired channel. (p. 100)
• Memory channel contents appear in the memory chan-
nel readout (below the frequency readout).
• "--.---.--" appears if the selected memory channel is a
blank channel (and does not have contents).
e Push and hold [MW] for 1 sec. to program the dis-
played frequency, operating mode, etc., into the
memory channel.

D Programming in memory mode

q Select the desired memory channel with [∫]/[√] in
memory mode.
• Memory channel contents appear in the memory chan-
nel readout instead of the frequency readout.
• No indication appears if the selected memory channel
is a blank channel (and does not have contents).
w Set the desired frequency and operating mode in
memory mode.
• To program a blank channel, use direct frequency entry
with the keypad or memo pads, etc. (p. 28)
e Push and hold [MW] for 1 sec. to program the dis-
played frequency and operating mode into the
memory channel.
101
[EXAMPLE]:
Programming 7.088 MHz/LSB into memory channel 12.
7
SSB
3
or
Beep
MW
Push for 1 sec.
Beep
Beep
[EXAMPLE]:
Programming 21.280 MHz/USB into memory channel 19.
or then
Beep
MW
Push for 1 sec.
Beep
Beep
MW
21
SSB
7