Miscellaneous (Others) Set Mode - Icom IC-756PRO Instruction Manual

9
SET MODE

Miscellaneous (others) set mode

This item is used for a simple frequency check of the
transceiver.
See p. 76 for calibration procedure.
Turn the calibration marker OFF after checking the
frequency of the transceiver.
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration.
The volume level can be set in level set mode. (p. 65)
A beep sounds when an operating frequency enters
or exits an amateur band. This functions independent
of the confirmation beep setting (above).
The volume level can be set in level set mode. (p. 65)
The [RF/SQL] control can be set as the RF/squelch
control (default), the squelch control only (RF gain is
fixed at maximum) or 'Auto' (RF gain control in SSB,
CW and RTTY; squelch control in AM and FM).
See p. 3 for details.
When this item is set to ON, pushing [DUALWATCH]
for 2 sec. sets the sub readout frequency to the main
readout frequency and activates dualwatch operation.
See p. 31 for details.
When this item is set to ON, pushing [SPLIT] for 2
sec. sets the sub readout frequency to the main read-
out frequency and activates split operation.
See p. 33 for details.
68
Calibration marker ON
Confirmation beep ON
(default)
Band edge beep ON
(default)
[RF/SQL] control as RF/squelch control
(default)
[RF/SQL] control as squelch control
[RF/SQL] control as RF gain control in
SSB, CW and RTTY; squelch control in
AM and FM
Quick dualwatch ON
(default)
Quick split ON
(default)
Calibration marker OFF
(default)
Confirmation beep OFF
Band edge beep OFF
Quick dualwatch OFF
Quick split OFF