Lamp And Filter Replacement - Christie Roadster S+12K Setup Manual

Maintenance
Lamp and Filter 
Replacement
Power Cord 
and Attachments
4-2

Do not operate the projector close to water, such as near a swimming pool. Do
not operate in extremely humid environments.

Do not place the projector on an unstable cart, stand or table. A projector and cart
combination should be used with care. Sudden stops, excessive force and uneven
surfaces may cause the projector and cart combination to overturn.

Only use Christie-approved ceiling mount fixture, if the projector is to be ceiling
mounted.
Do not operate the Bubble lamp for more than the lamp's warranty limit; risk
LAMP:
of the lamp shattering increases as a result of changes in the quartz glass that occur
with use. Operation beyond the lamp's warranty limit also significantly reduces
brightness output.
Wait approximately five minutes after powering down the
projector to allow internal cooling fans to stop and for the lamp
to cool sufficiently before removing.
Never attempt to remove the lamp housing directly after use.
The lamp is under great pressure when hot and may explode,
causing personal injury and/or property damage. Allow cooling
The Bubble lamp operates at a very high temperature and pressure. Failure to allow
the lamp to sufficiently cool prior to handling could result in an explosion causing
personal injury and/or property damage. After turning the projector off it is important
that you wait at least five minutes before unplugging it. This provides enough time
for the internal lamp cooling fans to cool the lamp and to automatically shut off. Cool
completely before handling.
Use only lamps supplied by Christie. Use lamps of the correct
wattage for your projector model when replacing.
Use Christie approved filters ONLY.
Replace the filter when you replace the lamp or sooner if required. It is
FILTER:
important the filter be replaced regularly to ensure sufficient airflow through the
projector, otherwise it could cause the projector to overheat.
Refer to 4.4, Replacing the Lamp and Filter for the complete replacement
procedure.
The North American rated line cord is provided with each projector. Ensure
that you are using a line cord that meets the appropriate rating standards.
Only use attachments or accessories recommended by Christie, such as the specific
power cord supplied. Use of other attachments or accessories with this projector may
result in the risk of fire, shock or personal injury.
WARNING
completely.
WARNING
WARNING
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
020-100342-02 Rev. 1 (04-2011)