Jetta 2011 ➤ , Jetta Hybrid 2013 ➤
General body repairs, interior - Edition 06.2012
Installing
– Install in reverse order of removal.
Note
Before installing, check all fasteners for damage and renew if
♦
necessary.
Following installation, ensure that trim is positioned in door
♦
seal beading.
4.3
Removing and installing lower A-pillar
trim on driver side
Special tools and workshop equipment required
♦ Removal wedge -3409-
Removing
– Release sill panel moulding from body in area of overlap to
lower trim of A-pillar
– Remove dash panel end covers
– Remove centre A-pillar trim
– Remove bonnet operating lever -3- ⇒ General body repairs,
exterior; Rep. gr. 55 ; Bonnet .
– Remove clip -2-.
– Detach trim -1- from body -direction of arrow B-. While doing
so, detach trim from door seal beading.
– Remove trim -1- from mounting -direction of arrow A-.
194
Rep. gr.70 - Trim, insulation
⇒ page 206
.
⇒ page 163
⇒ page 192
.
.