Dual Rs-232 Optional Module Mounting - Visonic PowerMaster-10 Installer's Manual

Caution! When mounting the PGM-5 module it is strongly recommended to route the cable as shown in Figure
3.18 to prevent interference which may occur if routed too close to the control panel antennas.
A
B
A. Front unit
B. Back unit
C. PowerMaster-30 connector
D. PGM-5 Module
E. Wiring
F. Flat cable

2.3.8 DUAL RS-232 Optional Module Mounting

The DUAL RS-232 is a Module that enables connection of any two simultaneous devices, such as Local PC
programming or GSM Module.
The GSM unit enables the PowerMaster-30 system to operate over a cellular network (for details regarding the
GSM modem features and connections, refer to the GSM Modem installation instructions).
1. To install the DUAL RS-232 module into
the control panel, press it into the marked
location (see Figure 3.19) until a click is
heard.
2. Connect a local PC or GSM module, to
one of the DUAL RS-232 module
connectors, as shown in Figure 3.19.
A. DUAL RS-232 Module
B. Connector for PC
C. Connector for GSM or PC
D. Back unit
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
C
F
Figure 3.18 – PGM-5 Module Mounting
Figure 3.19 –Dual RS-232 Module Mounting
D
D
E
A
B
C
25