Diagnostics; General Guidance - "Diagnostics" Flow-Chart & Menu Options - Visonic PowerMaster-10 Installer's Manual

3.9 Diagnostics

3.9.1 General Guidance – "Diagnostics" Flow-Chart & Menu Options
The DIAGNOSTICS menu enables you to test your system and to verify proper operation of your PowerMaster
panel, wireless devices attached to it and the communication (GSM/GPRS) modules.
IMPORTANT! Reliable reception must be assured during the initial testing and also throughout subsequent
system maintenance. A device should not be installed in location where signal strength is "poor". If you
get "poor" signal strength from a certain device, simply re-locate it and re-test until a "good" or "strong" signal
strength is received. This principle should be followed throughout the diagnostic test procedure.
The diagnostic test process is shown below.
The
07.DIAGNOSTICS
features and parameters related to the communication and reporting as follows (see detailed list in Step-3 of the
chart below):
Option
WL DEVICES
GSM/GPRS
To enter the
07.DIAGNOSTICS
Step 1
Select [1]
07. DIAGNOSTICS
INSTALLER MODE
07. DIAGNOSTICS
72
menu contains several sub-menu options, each covering a group of configurable
Description of Option Features and Parameters
Describes how to test the devices attached to the PowerMaster panel,
review devices' status and RF signal status. You can test all devices, test
single device, review devices status and review RF problems, in case of
any.
Describes how to test the GSM/GPRS communication module.
menu and to select and configure an option, proceed as follows:
Step 2
Select Diagnostics
Sub-menu option
WL DEVICES
GSM/GPRS
[2] Select the diagnostics you want to perform
TEST ALL DEVICES
SHOW ALL DEVICES
SHOW RF PROBLEMS
TEST ONE DEVICE
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
Step 3
Contact sensors
Motion sensors
Repeaters
Section
4.8.2
4.8.3
Step
4
[3]
[4]
See
section
4.8.2
4.8.3