Connecting To The Telephone Line; System Planning & Programming - Visonic PowerMaster-10 Installer's Manual

2.3.4 Connecting to the Telephone Line

Connect the telephone cable to the SET connector and connect the telephone line cable to the LINE connector
(through the desired wiring cable entry).
Note: The telephone cable should be no longer than 3 meters.
A. LINE
B. SET
C. Tel line wall jack
A. LINE
B. SET
C. RJ-31X cord
D. 8-position RJ-31X plug
E. Brown
F. Red
Phone wiring in the UK: Line terminals must be connected to pins 2 and 5 of the wall jack.
For all installations: If DSL service is present on the phone line, you must route the phone line through a DSL
filter (refer to MESSAGE TO THE INSTALLER on page 2 for further details).
2.3.5 System Planning & Programming
It pays to plan ahead - use the tables in appendices A and B at the end of this guide to register the intended
location of each detector, the holder and assignment of each transmitter.
Gather up all transmitters and detectors used in the system and mark each one in accordance with your
deployment plan.
Program the system now as instructed in the programming section.
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
PHONE WIRING
PHONE WIRING IN NORTH AMERICA
B
A
G. Green
H. Gray
RJ-31X jack
I.
J. Line from street
K. House phones
Figure 3.16 –Phone Wiring
B
A
D
E
1
F
G
H
C
C
I
E
F
2 3 4
K
J
RJ-31X
5
7
6
G
H
23