Visonic PowerMaster-10 Installer's Manual page 70

Step 1
Select "PGM [1]
DEVICES" option
05:OUTPUTS
PGM DEVICES
– Entering the "PGM Output" Menu
To Select an Option:
[1]
Enter the Installer Menu and select the
[2]
Select the sub-menu option you need, for example:
[3]
Select the parameter you wish to configure for example:
[4] To continue, go to the Section of the selected sub-menu option and look for the option you wish to
configure. After configuring the selected parameter the display returns to step 3.
[5] The "toggle" option setting is available only for "PGM: BY KEYFOB".
[6] Select "Turn on" to activate the PGM device, "Turn off" to stop the PGM device and "disable" to deactivate
the PGM device.
[7] The time selection will take effect when the "activate PULSE" is enabled.
[8] Select "start" / "stop" and enter the desired time.
To Change the Configuration of the Selected Option:
When entering the selected option, the display shows the default (or the previously selected) setting marked
with ( ).
If you wish to change the configuration, scroll
wish and press
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
Step 2
Select "PGM DEVICE [2]
01" or "LOCKOUT
TIME"
PGM DEVICE 01
LOCKOUT TIME
05:OUTPUTS
to confirm. When done the display bring you back to Step 3.
Step 3
[3]
Select a mode to
configure
PGM: BY ARM AWAY
PGM: BY ARM HOME
PGM: BY DISARM
PGM: BY MEMORY
PGM: BY DELAY
PGM: BY KEYFOB
PGM: BY SENSOR
PGM:BY LINE FAIL
PGM: PULSE TIME
start – HH:MM A
stop – HH:MM A
[8]
option (see section 3.2).
PGM DEVICE 01
PGM: BY MEMORY
the "Option settings" menu and select the setting you
Step 4
Select the new [4]
setting
disable
turn ON
turn OFF
activate PULSE
toggle
[5] [6]
Zone A Z:_ _
Zone B Z:_ _
Zone C Z:_ _
by line fail NO
by line failYES
pulse time 2s
pulse time 30s
pulse time 2m
pulse time 4m
[7]
.
Step 5
Return
to step
3.
See
[4]
69