Visonic PowerMaster-10 Installer's Manual page 67

Option
PSTN UP/DOWNLOAD
Remote access
Mast. UL/DL code
Inst. UL/DL code
UL/DL modes
(Return)
GPRS UP/DOWNLOAD
Panel SIM Tel.#
Previously known
as "My SIM Tel.#"
1st caller ID#
2nd caller ID#
(Return)
66
Configuration Instructions
Here you configure the Upload/Download functionality via PSTN. The functionality is
determined through a sub-menu of the PSTN UP/DOWNLOAD
To program:
Press to enter the
each of the the five sub-menu options as shown below. When done, press
return.
Here you enable or disable the remote access to the system. If disabled, the system
can not be accessed from remote thereby inhibiting the Upload/Download and the
Remote Control via PSTN or GSM analog communication channels (see Chapter-5 in
the User's Guide – Remote Control by Telephone).
Option settings: enabled (default); disabled.
Here you determine the 4-digit password code that will allow the Master installer to
access the system from remote and upload or download data into the PowerMaster-10
panel.
Enter the 4-digit Master Installer download code ("0000" is not a valid code and must not
be used).
Here you determine the 4-digit password code that will allow the Installer to access the
system from remote and upload or download data into the PowerMaster-10 panel.
Enter the 4-digit Installer download code ("0000" is not a valid code and must not be
used).
Note: The installer can configure via UL/DL only the options he is authorized to
configure from the control panel.
Here you determine whether the downloading/uploading can be performed in Disarm
mode (state) only or in all modes (i.e. Away, Home & Disarm).
Option settings: any time (default) or when system OFF.
Here you configure the Upload/Download functionality via GPRS. The functionality is
determined through a sub-menu of the GPRS UP/DOWNLOAD
To program:
Press to enter the
each of the three sub-menu options as shown below. When done, press
return.
Here you enter the PowerMaster-10 SIM card telephone number. The PowerManage
server at the Monitoring Station sends an SMS message to this number when it needs
the panel to call back the PowerManage server via GPRS for initiating the uploading /
downloading process.
Enter the SIM card telephone number of the panel's GSM module.
Here you enter the "Caller ID" (i.e. telephone number) from which Monitoring Station
#1 (C.S.1) is supposed to send the SMS message to the control panel for initiating the
Up/Download process. If the sender's Caller ID matches with the "1
PowerMaster-10 will call back the PowerManage server using "IP RCVR 1" address as
configured in Section 3.6.4. option 21.
Enter the Caller ID number of the SMS sender from Monitoring Station #1.
Note: Caller ID#1 must contain at least 6 digits otherwise the process will not work.
Here you enter the "Caller ID" (i.e. telephone number) from which Monitoring Station
#2 (C.S.2) is supposed to send the SMS message to the control panel for initiating the
Up/Download process. If the sender's Caller ID matches with the "2
PSTN UP/DOWNLOAD option as shown below.
PSTN UP/DOWNLOAD PSTN UP/DOWNLOAD
sub menu and then select and configure
PSTN UP/DOWNLOAD
GPRS UP/DOWNLOAD option as shown below.
GPRS UP/DOWNLOAD GPRS UP/DOWNLOAD
sub menu and then select and configure
GPRS UP/DOWNLOAD
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
to
to
st
caller ID#" , the
nd
caller ID#" , the