Powermaster-10 Installation; Opening The Powermaster-10 Control Panel And Bracket Mounting - Visonic PowerMaster-10 Installer's Manual

2.2 PowerMaster-10 Installation

Required tool: Philips screwdriver #2.
PowerMaster-10 mounting process is shown in Figures 3.1 - 3.2.

2.2.1 Opening the PowerMaster-10 Control Panel and Bracket Mounting

To Mount the Unit:
1. Release the screws
2. Remove the front cover
3. Mark 4 drilling points on the mounting surface
4. Drill 4 holes and insert wall anchors
5. Fasten the back unit with 4 screws
WARNING! When plugging SIREN & ZONE terminals back into place, be sure to align them carefully with the pins
on the PCB. Misaligned or reverse insertion of terminals may cause internal damage to the PowerMaster-10!
10
1
A
4
Figure 3.1 – Back Unit Mounting
A. Mounting surface
B. Back unit
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
A
B
3
A
5