– Periodic Test
[1]
If the panel's display reads
being tested.
[2]
Not including Siren and Temperature Sensors
[3]
After reviewing all untested devices the control panel will read "<OK> TO LEAVE". You can now do one of the
following: press
to exit the testing procedure.
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
Press
to test the selected device. The following screen will appear:
Z01 ACTIVATE NOW
.
Walk throughout the site to test the detectors / sensors or press any key of the
selected handheld device to initiate the test.
During testing, you can also check the signal strength indication of each device, (for
further details, refer to the device Installation Instructions).
At the end of the test process, the panel will revert to:
SIREN P
to abort the testing procedure; press
, this indicates that the control panel's siren is currently
to continue the testing procedure; or press
TEST ONE DEVICE
.
81