Visonic PowerMaster-10 Installer's Manual page 8

Conducting walk
tests
Up to 3 partitions
∗
Two-way voice
communication ∗∗
Device configuration
from the panel
Device configuration
defaults
SirenNet -
distributed siren
using Smoke
detectors
Integrated built-in
Siren
Refers to PowerMaster-30 only
∗
∗∗ Refers to PowerMaster-30 with voice option only
D-303222 PowerMaster-10 / PowerMaster-30 Installer's Guide
about the received signal strength from
each transmitter and to review
accumulated data after the test.
You can conduct a periodic test at least
once a week and after an alarm event.
The walk test can be conducted from
remote locations, with assistance from
anyone in the house.
The partitioning feature divides your alarm
system into distinct areas each of which
operates as an individual alarm system.
Partitioning can be used in installations
where shared security systems are more
practical, such as a home office or
warehouse building.
Partitioning is not available with some
panels and when available must be
enabled and properly configured.
The PowerMaster system enables voice
communication with Monitoring Stations
Each PowerG device has its own settings
which can be configured through the
control panel by entering the "DEVICE
SETTINGS" menu.
The defaults of device parameters can be
configured according to your personal
preferences for each new device enrolled
in the system. You can use a certain set of
defaults for a certain group of devices and
change the defaults for another group.
The smoke detector includes a siren with
four sounder types that can activate
burglary, gas, fire and flood alarms.
The control panel has a high-powered built-
in siren that sounds in case of alarm.
Diagnostics
To conduct a walk test locally from the
panel: see Chapter 4 Periodic Test
To conduct a walk test remotely: refer
to the Remote Programmer PC software
User's Guide, Chapter 6 Data Details
Tables.
To understand partitioning: see
Appendix C. Working with Partitions and
Appendix A in the User's Guide.
To enable partitioning: see section 3.14
Partitioning
To setup a partitioned system: see
section 3.4.2 Adding (Enrolling) New
Wireless Devices or Wired Sensors
To configure the two way voice channel
settings of the PowerMaster: see
section 3.6.4 Configuring Events
Reporting to Monitoring Stations
To configure the device parameters:
refer to the device's Installation
Instructions
To define defaults for device
parameters: see section 3.4.6 Defining
Configuration Defaults for "Device
Settings"
To use SirenNet: refer to the SMD-426
PG2 / SMD-427 PG2 Installation
Instructions
To understand the wiring of the internal
siren: see section 2.3.9 Optional
Expander Module Mounting
To define whether or not the internal
siren will sound alarms: see section
3.5.5 Configuring Sirens Functionality
7