Built-In Smdr/Pms On Ip (Mp) - NEC NEAX 2000 IPS Installation Manual

Built-in SMDR/PMS on IP (MP)

[Series 3400 software enhancement]
The ETHER card (PZ-M606-A) on the MP card provides on LAN interface port for SMDR/PMS.
Connect the SMDR/PMS terminal to LAN port of the PZ-M606A-A card on the PN-CP24-A/CP24-B/
CP24-C/CP24-D card using 10BASE-T/100BASE-TX cable as shown below.
PBX
PN-CP24-A
/CP24-B
/CP24-C
/CP24-D
The LAN interface specifications are listed below.
Item
Physical layer
Connection layer
TCP/IP protocol
Socket interface
Transport protocol
Application port number
Number of connection
Client/Server
Transmission code
Quasi-normal restriction condition
NOTE: The MP card in Main site communicates with the SMDR/PMS terminal. Therefore, in the com-
munication settings in SMDR/PMS terminal side, set the IP address to connected to the address
specified by office data (CM0BY=00>00 or CM0BY=02>03), and application port number
shown in the above table.
SMDR/PMS Terminal Connection
LAN
10BASE-T/100BASE-TX cable
PZ-M606-A
Ethernet
The Ethernet packet format complies with the DIX standard.
ARP,IP,ICMP,UDP,TCP
Complies with 4.3 BSD socket interface
TCP stream type protocol
SMDR : 60010 (fixed)
PMS : 60050 (fixed)
1
Client : SMDR/PMS terminal
Server: PBX
7-bit ASCII code
1. When connection is closed.
2. Status monitoring text
Switching HUB
TO LAN PORT
Specifications
– 268 –
Built-in SMDR/PMS on IP (MP)
SMDR/PMS
NWA-008841-001 Rev.5.0
90ch2002.fm
JULY/1/2006