NEC NEAX 2000 IPS Installation Manual page 250

<Receiver Volume Set>
This item specifies the receiver volume.
STEP1: Display Configuration Menu P4.
STEP2: Press the numeric key 3 (RECEIVER VOLUME SET).
STEP3: Press the desired numeric key. An asterisk (*) shows the selected number.
1. When specifying "1:SYSTEM DEFAULT", the receiver volume is set to the default level of the
DLC card.
2. When specifying "2:DEFAULT BY CALL", the receiver volume is set to the level in accordance
with the system default.
3. When specifying "3:SAME AS PREVIOUS CALL", the receiver volume is set to the level
adjusted by the UP/DOWN key.
4. When specifying "4:QUIET PLACE", the receiver volume is set to the level (-8dB) lower than
System Default.
STEP4: Press the SRC key. The display returns to Configuration Menu.
STEP5: Press the Answer key to update the configuration data.
When canceling update, press the Release key.
When specifying other item, press the DEST key.
When returning previous item, press the SRC key.
[CONFIG MENU P4] VER x
1: 2ND RINGING
2: RINGING
3: RECEIVER VOLUME SET
[RECEIVER VOLUME SET]
* 1: SYSTEM DEFAULT
2: DEFAULT BY CALL
3: SAME AS PREVIOUS CALL
[CONFIG MENU P4] VER x
1: 2ND RINGING
2: RINGING
3: RECEIVER VOLUME SET
Page 221
SRC: prev page
DEST: next page
Release: exit
Answer: update
SRC: menu
4: QUIET PLACE
SRC: prev page
DEST: next page
Release: exit
Answer: update
– 234 –
SN716 DESKCON (DLC)
Default setting:
"1:SYSTEM DEFAULT"
Page 225
NWA-008841-001 Rev.5.0
90ch2002.fm