NEC NEAX 2000 IPS Installation Manual page 51

EQUIPMENT FUNCTIONAL
NAME
PN-32IPLA/ IP-PAD
PN-32IPLA-A
PN-4LCC LC
PN-4LCD-A LC
PN-4LCE LC
[For
Australia]
PN-4LCF LC
[For
Australia]
PN-4LCK LC
[For China]
NOTE: IP-PAD (PN-32IPLA) card does not support FAX relay.
Line/Trunk Card Name and Function
NAME
32-channel IP-PAD Card
Provides LAN Interface, Packet Assembly/Disassembly to accom-
modate Legacy Line/Trunk interface.
Provides voice compression DSP control functions such as voice
compression control, DTMF relay and FAX relay.
• Voice compression protocol: G.711 (64Kbps)
• FAX protocol: Pass-through (G.711)
Used together with maximum two 16VCT cards.
Provides Auto Negotiation function (Set to ON/OFF by the switch
setting).
Two cards can be accommodated per built-in FP/FP card, maxi-
mum 8 per system.
100 BASE-TX twisted pair cable is connected directly to this card.
4-line Analog Line Circuit Card for Single Line Telephones
Loop resistance : Maximum 600 Ω (including telephone set)
Provides Line Test function.
4-line Analog Line Circuit Card for Single Line Telephones
Loop resistance : Maximum 600 Ω (including telephone set)
Provides momentary open and Message Waiting Lamp control,
Line Test functions for each circuit.
Equipped with +80 V DC-DC on-board power supply.
4-line Analog Line Circuit Card for Single Line Telephones
Loop resistance : Maximum 600 Ω (including telephone set)
Provides Line Test function.
4-line Analog Line Circuit Card for Single Line Telephones
Loop resistance : Maximum 600 Ω (including telephone set)
Provides Message Waiting Lamp control, Line Test functions for
each circuit, and reverse function for only No.3 circuit.
Equipped with +80 V DC-DC on-board power supply.
4-line Analog Line Circuit Card for Single Line Telephones
Loop resistance : Maximum 600 Ω (including telephone set)
Provides Line Test function.
CHAPTER 1 GENERAL INFORMATION
FUNCTION
– 35 –
EQUIPMENT NAME AND FUNCTION
Continued on next page
NWA-008841-001 Rev.5.0
OCTOBER/31/2005
NOTE
90ch1001.fm