NEC NEAX 2000 IPS Installation Manual page 601

Switch Settings
SWITCH NAME
SW
(Piano Key SW)
ON
1
2
3
4
The figure in the SWITCH NAME column and the position of
umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
SWITCH SETTING
NUMBER POSITION
ON
1
NOTE 1
NOTE 2
OFF
ON
2
NOTE 1
NOTE 2
OFF
3
OFF
ON
4
OFF
FUNCTION
Source clock signal from network is
sent to the PLO0 input on MP card
(1.5 MHz clock).
Source clock signal from network is not
sent to the PLO0 input on MP card
(1.5 MHz clock).
Source clock signal from network is
sent to the PLO1 input on MP card
(1.5 MHz clock).
Source clock signal from network is not
sent to the PLO1 input on MP card
(1.5 MHz clock).
Not used
WAN port or T1 interface for PBX are
available.
Only WAN port is available.
– 585 –
PZ-M649 (DTI)
in the SETTING POSITION col-
Continued on next page
NWA-008841-001 Rev.5.0
CHECK
90ch3004.fm