Wall Mounting Installation - NEC NEAX 2000 IPS Installation Manual

Wall Mounting Installation

Start
Checkup
before installation
Detaching
Front Cover
Marking
Installation of Module
Multiple-Module
Configuration
Checking
End
• Check the site for installing the PBX with the work drawing to verify that the
required floor space is ensured and that service entrances and ducts for trunk/
extension cables, power cables and grounding conductors have been properly
worked at correct positions. See
Page 84, Page 85
• Detach the front cover of each Module. See
COVER". Page 88
• Mark hole positions for installation of the PBX main equipment. See
Marking for HANGER
• Secure the HANGER ASSEM to the wall.
• Hang the PIM to the HANGER ASSEM. See
Page 102
SEM".
NOTE:
The BATTM cannot be installed on the wall.
• After hanging each PIM to the respective HANGER ASSEMs, connect PIMs
using screws. See "Connection of
• Carefully review every step above to check that all necessary screws have been
properly placed and tightened.
"Floor Space"
"Detaching FRONT
ASSEM". Page 101
Modules".
– 100 –
CHAPTER 2 INSTALLATION
INSTALLATION OF MAIN EQUIPMENT
and "Cable Hole Location".
"Hanging PIM to HANGER AS-
Page 94
NWA-008841-001 Rev.5.0
"Wall
90ch2001.fm