Application Processor Card - NEC NEAX 2000 IPS Installation Manual

Application Processor Card

This table shows the names and functions of each application processor card.
NOTE: PN-AP01 (AP01) card and PN-CC01 (ETHER) card cannot be mounted in NEAX 2000 IPS.
Application Processor Card Name and Function
EQUIPMENT FUNCTIONAL
NAME
PN-AP00-B DBM
[For PCS]
PN-AP00-B AP00
PN-AP00-D AP00
PN-BRTA BRT
PN-2BRTC BRT
PN-2BRTK BRT
[For UK]
PN-4BRTA-A BRT
PN-24CCTA CCT
NAME
Data Base Module Card for WCS Roaming function
One card per system.
Supports number extension of PS.
[Series 3400 software required]
Application Processor Card
Provides four RS-232C ports, and is used for SMDR, Hotel
Printer, CIS, PMS, MCI functions.
(For PMS function, PN-AP00-B with MRCA program is not
available.)
One card per system.
Application Processor Card
Provides four RS-232C ports, and is used for SMDR, Hotel
Printer, CIS, MCI functions.
One card per system.
1-line Basic Rate (2B+D) Interface Trunk Card
Accommodates one 2-channel PCM digital lines.
2-line Basic Rate (2B+D) Interface Trunk Card
Accommodates two 2-channel PCM digital lines.
2-line Basic Rate (2B+D) Interface Trunk Card
Accommodates two 2-channel PCM digital lines.
4-line Basic Rate (2B+D) Interface Trunk Card
Accommodates four 2-channel PCM digital lines.
CCIS (1.5 Mbps) Trunk Card
Provides a built-in Common Channel Handler (CCH) of No.7
CCIS.
CHAPTER 1 GENERAL INFORMATION
FUNCTION
– 23 –
EQUIPMENT NAME AND FUNCTION
Continued on next page
NWA-008841-001 Rev.5.0
90ch1001.fm
JULY/1/2006