NEC NEAX 2000 IPS Installation Manual page 552

Switch Settings
SWITCH NAME
MB (Toggle SW)
ON
NOTE 1
SW0
(Piano Key SW)
OFF
4
3
2
1
ON
The figure in the SWITCH NAME column and the position of
umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
NOTE 1: When the power is on, flip the MB switch to ON (UP position) before plugging/unplugging the
circuit card.
NOTE 2:
When using the firmware program of SC-3330 IPS IPADT PROG-B1 or later for the PN-8IPLA
card, you may set the Auto Negotiation ON/OFF settings by the SW0-3. When using the firm-
ware program of SC-3213 IPS IPADT PROG-A1 for the PN-8IPLA card, Auto Negotiation
function is always set to ON.
SWITCH SETTING
NUMBER POSITION
UP
DOWN
1
OFF
2
OFF
ON
3
NOTE 2
OFF
4
OFF
FUNCTION
For make-busy
For normal operation
Not used
Not used
Auto Negotiation OFF
(100 Mbps [Full-Duplex] fixed)
Auto Negotiation ON
(Ethernet 10 Mbps/100 Mbps automatic
change)
Not used
– 536 –
PN-8IPLA (IP-PAD)
in the SETTING POSITION col-
NWA-008841-001 Rev.5.0
CHECK
90ch3004.fm
JULY/1/2006