NEC NEAX 2000 IPS Installation Manual page 35

This table shows the names and functions of installation hardware.
EQUIPMENT FUNCTIONAL
NAME
HANGER ASSEM (B)
MOUNTING BRACKET
19" RACK BRACKET (A)
19" RACK BRACKET (B)
I/F BRACKET ASSEM
BASE TRAY ASSEM
Installation Hardware Name and Function
NAME
Wall Hanger Assembly
One HANGER ASSEM is required per PIM for Wall Mounting
Installation.
Safety Mounting Bracket
Used as an overhead hanger for Floor Standing Installation. Wire,
chain or eyebolts are to be locally provided, to secure the bracket.
To be installed on the top PIM in four or more modules of stack. It
provides 1.1G shockproof construction.
19-inch Rack Mounting Bracket Type A
One bracket is required for one PIM configuration.
One bracket is required for the top PIM of multiple module con-
figuration.
19-inch Rack Mounting Bracket Type B
One bracket is required for the bottom module of multiple module
configuration.
Inter Frame Bracket Assembly
Used to joint the frames in two-frame configuration, for Floor
Standing Installation.
Base Tray Assembly
One BASE TRAY is required per one frame for Floor Standing
Installation of Stationary Equipment.
CHAPTER 1 GENERAL INFORMATION
FUNCTION
– 19 –
EQUIPMENT NAME AND FUNCTION
NWA-008841-001 Rev.5.0
90ch1001.fm