NEC NEAX 2000 IPS Installation Manual page 462

Switch Settings
SWITCH NAME
SENSE
(Rotary SW)
F
4
NOTE 1
MB (Toggle SW)
ON
NOTE 2
MODE
(Rotary SW)
NOTE 1:
Set the groove on the switch to the desired position.
NOTE 2: When the power is on, flip the MB switch to ON (UP position) before plugging/unplugging the
circuit card.
NOTE 3: When you set the MODE switch of the IPT card to 0 (Auto Negotiation On), the communication
mode (Full-Duplex/Half-Duplex) and the communication speed (Ethernet 10 Mbps/100 Mbps)
of the Ethernet are adjusted to the switching HUB automatically. When you set the MODE
switch to 1 (Auto Negotiation Off), the communication mode of the Ethernet will be fixed to
Half-Duplex. And the communication speed will be set by SW2-1.
SWITCH SETTING
NUMBER POSITION
0-3 Not used
4-F Set the switch to match the AP Number (04-31) to be
set by CM05.
SW1-4: ON
AP No.
SW1-4: OFF
SW No.
UP
DOWN
0
0, 1
1
2-F
FUNCTION
04 05 06 07 08 09 10
20 21 22 23 24 25 26 27
4 5 6 7 8 9
For make-busy
For normal operation
Auto Negotiation ON
Auto Negotiation OFF
(Ethernet 10 Mbps/100 Mbps change
NOTE 3
by SW2-1)
Not used
– 446 –
11 12 13 14 15
28 29 30 31
A B C D E F
NOTE 3
Continued on next page
NWA-008841-001 Rev.5.0
PN-IPTB (IPT)
CHECK
90ch3003.fm