NEC NEAX 2000 IPS Installation Manual page 103

• Drilling
(1) Make a preliminary hole in the concrete, using a drill bit for small-diameter holes.
(2) Drill a hole in the concrete with a drill suitable for a plug bolt a little deeper than the plug bolt
length.
Anchor Bolt Size :10 mm (0.39 inch) DIA for Fixed Equipment
(3) Insert the anchor bolt into the hole.
(4) Push anchor bolt until the bolt stays permanently in place.
(5) Turn bolt counterclockwise and remove.
(6) Insert bolts correctly into the holes for equipment installation, then tighten them properly.
(1)
6 mm (0.24 inch) DIA for Stationary Equipment
Drilling Instructions for Anchor Bolt
(2) (3)
– 87 –
CHAPTER 2 INSTALLATION
INSTALLATION OF MAIN EQUIPMENT
(4) (5) (6)
NWA-008841-001 Rev.5.0
90ch2001.fm