Table of Contents
Advertisement
14.03 RUNNING WITHOUT A TERMINAL
The VIPer can boot up without a screen or terminal attached. However, if VT100 Mode is
desired, but the terminal is to be disconnected, you must ensure the control lines are in an
active state. Failing this, the system may "hang" while waiting for the control lines to
become active. Wiring the system according to Diagram 14-2 allows the lines to remain
active. This does not apply if the VT100 jumper is not set.
Furthermore, you can run without any console at all simply by not enabling VT100 Mode
and by not installing a video card.
VT100 Mode
14-4
Advertisement
Table of Contents
