Basic Commands - Teknor Industrial Computers VIPer 821 Technical Reference Manual

VIPer 821 - Technical Reference Manual
Whenever you are not sure about a certain setting, refer to the list of default values. Default
values are provided in the event that a value has been changed and one wishes to restore
original values.
Loading the BIOS or SETUP defaults will affect all the options and will reset options
previously altered. Loading default values at the main menu changes setups for all screens
while loading default values in a particular setup screen will affect only that screen.
BIOS default settings consist of the safest set of parameters. Use it if the system is behaving
erratically. They should always work but do not provide optimal system performance.
SETUP default values provide optimum performance for all devices and system features.
CAUTION
Before modifying CMOS setup parameters, ensure that the Battery jumper is
installed (See Setting Jumpers Section).
The board is capable of operating without the onboard battery if the CMOS
values are saved into the Flash memory.
4.1

BASIC COMMANDS

Operations within each menu and screen are summarized below:
Up arrow (↑ ↑ ↑ ↑ )
Down arrow (↓ ↓ ↓ ↓ )
Left arrow (← ← ← ← )
Right arrow (→ → → → )
Esc key
PgUp key
PgDn key
+ key
- key
F5 key
F6 key
F7 key
F10 key
Move to previous item.
Move to next item.
Move to the item to the left.
Move to the item to the right.
In Main Menu: Quit settings with saving options.
In sub-menus: Exit and return to Main Menu.
Increase the numeric value or make changes.
Decrease the numeric value or make changes.
(Numeric keypad) Increase the numeric value or make changes.
(Numeric keypad) Decrease the numeric value or make changes.
Restore the previous setup values.
Load the default setup values from BIOS Default Table.
Load the setup values from the Setup Default Table.
Save all the CMOS changes.
4-2