Removing The Right And Left Ld Roller Assembly - Epson Stylus Color 400 Service Manual

EPSON Stylus Color 400 Service Manual

3.2.4.6.2 Removing the Right and Left LD Roller Assembly

1. Disassemble the ASF assembly and remove the paper feed roller assembly and hopper
assembly from the ASF body. (Refer to 3.2.4.6)
2. Take out right and left compression springs 1.66 from the back of hopper assembly.
3. Pull out the cam part of the hopper assembly from the frame hole located on the right side of paper
feed roller assembly.
4. Pull out the LD roller axis.
The paper feed roller assembly and hopper assembly should be disconnected by now.
5. Release the hook of LD roller assembly at the axis hole of the paper feed roller assembly.
Also, release the fixed hook of cover roller LD and remove the LD roller assembly.


When installing the LD roller assembly, make sure that the hooks are hung on the paper feed
assembly.


During assembly, when setting the compression spring 1.66 to the spring installation position in
the paper feed assembly, hang the spring on the hook temporarily. Also, do not forget to release
the hooks of these springs from the holes located on the back of paper feed assembly by
rotating the spring. (Refer to the figure below.)
3-20
WORK POINT
Figure 3-17. Disassembly of Paper Feed Roller Assembly
Rev. A