Ink System Unit - Epson Stylus Office T1110 Service Manual

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
Hook both rear ends of the Paper EJ Frame Assy onto the tabs
on the Main Frame.
Figure 4-108. Reinstalling the Paper EJ Frame Assy
Align the tabs with the five positioning holes.
See Figure 4-106 (p.106)
Tighten the screws in the order shown in
After replacing or removing the Paper EJ Frame Assy, always make
A D J U S T M E N T
R E Q U I R E D
the required adjustments referring to the following.
• "Chapter 5
Adjustment
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Disassembly And Assembly
高速行式打印机 http://www.lineprinter.com.cn/
Tabs
Figure 4-106
(p.128)"
Disassembling the Printer Mechanism

4.4.13 Ink System Unit

1. Remove the Paper EJ Frame Assy. (p.106)
2. Release the Carriage Lock, and move the Carriage Unit to the center.
Locking/Releasing the Carriage (p.65).)
3. Release the two tabs that secure the clamps to the Upper Shield Plate, and remove
the two clamps.
4. Disconnect the Pump Motor cable from the connector CN117 on the Main Board.
5. Remove the Pump Motor cable from the Cord Keep.
Cord Keep
Pump Motor cable
Figure 4-109. Removing the Pump Motor cable
Referring to Figure
the frame.
Referring to Figure
Relay connector cable and the CR Motor connector cable.
打印机驱动下载 http://www.printerwhy.com/
Revision A
(Refer to 4.1.5
Tabs
Main Board
CN117
Clamps
4-147, attach two pieces of acetate tape to
4-148, route the Pump Motor cable, the
Confidential
107