Data Overwrite Security Unit Type G (G874); Before You Begin The Procedure; Seal Check And Removal - Ricoh G133 Service Manual

7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the SD card from SD Card Slot 3.
This step assumes that the application programs in the SD card are used by
the machine.
10. Turn the main switch on.
11. Check that the application programs run normally.
12. Make sure that the machine can recognize the option (see 'Check All Connections' at
the end of this section).

1.11.3 DATA OVERWRITE SECURITY UNIT TYPE G (G874)

Before You Begin the Procedure

Confirm that the Data Overwrite Security unit SD card is the correct type for the machine.
The correct type for this machine is type "G".
If the NVRAM is replaced, then the data overwrite security feature must be
replaced with the new data overwrite security option.

Seal Check and Removal

You must check the box seals to make sure that they were not removed after
the items were sealed in the box at the factory before you do the installation.
1. Check the box seals [A] on each corner of the box.
Make sure that a tape is attached to each corner.
The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not
install the components in the box.
2. If the surfaces of the tapes do not show "VOID", remove them from the corners of the
SM 1-57
Controller Options
G133