Ricoh G133 Service Manual page 344

Service Mode Table
Specifies the time for keeping the target temperature after recovery
(SP1105-083) without any jobs.
1115 [Stand-by Idling]
Interval
001
Specifies the interval between idling during stand-by mode.
This idling during the stand-by mode prevents the roller deformation.
Idling Time
002
Specifies the length of each idling operation during stand-by mode.
1116 [Ends Temp. Correction] Not used
001 Mode: X1
002 Mode: X2
003 Mode: X3
004 Detection Hysteresis
005 Saturation Temp.
006 Saturation Temp.: Margin
1159 [Fusing Jam Detection]
SC Display
001
Enables or disables the fusing consecutive jam detection.
If this SP is set to "1" (default: 0), SC559 occurs when the machine detects the
paper jam three times consecutively at the fusing unit.
G133
*ENG
[1 to 240 / 60 / 1 min/step]
*ENG [0 to 60 / 0.7 / 0.1 sec/step]
*ENG
[0 to 999 / 40 / 1 sheet/step]
*ENG [0 to 999 / 70 / 1 sheet /step]
*ENG [0 to 999 / 100 / 1 sheet /step]
*ENG [1 to 20 / 5 / 1deg/step]
*ENG
[180 to 230 / 210 / defe/step]
*ENG [30 to 130 / 130 / 1deg/step]
[0 or 1 / 0 / 1 /step]
*ENG
0: Disable, 1: Enable
5-22 SM