Ricoh G133 Service Manual page 993

Finisher Jam Detection
Display Mode
R4 Shift
R5 to R7 Staple
Booklet
R8 to Staple
R12 (B700
Only)
SM
Jam
After finisher entrance sensor goes ON, upper
Upper tray exit
tray exit sensor does not go ON even after
sensor late
enough time to feed 485 mm.
After finisher entrance sensor goes OFF, upper
Upper tray exit
tray exit sensor does not go OFF even after
sensor lag
enough time to feed 650 mm.
After finisher entrance sensor goes ON,
Pre-stack tray
pre-stack tray exit sensor does not go ON even
exit sensor lag
after enough time to feed 650 mm.
After finisher entrance sensor goes ON,
Pre-stack tray
pre-stack tray exit sensor does not go OFF
exit sensor late
even after enough time to feed 1650 mm.
The fold unit entrance sensor goes not go ON
Fold unit
after enough time has elapsed to feed 1.5 times
entrance
the length of the stack after the leading edge of
sensor late
the stack reaches the stack present sensor
(S26)
(S32).
Fold unit exit The fold unit exit sensor does not go ON after
sensor late enough time has elapsed for the stack to feed
(S31) 1.5 times its length from the fold position.
Fold unit exit After the fold unit exit sensor goes ON, it does
sensor lag not go OFF after enough time has elapsed to
(S31) feed 442.9 mm.
73
What It Means
B804/B805