Table of Contents
Advertisement
3.
Turn the main switch off. Then put a blank formatted SD card into the SD card slot 3.
4.
Turn the main switch on.
5.
Copy the NVRAM data (
(SP5846-051) to the SD card if possible.
An error message shows if local user information cannot be stored in an SD
card because the capacity is not enough.
You cannot do this procedure if the SD card is write-protected.
6.
Enter SP mode. Then print out the SMC reports (
7.
Turn off the main switch. Then unplug the power cord.
8.
Replace the NVRAM on the controller. Then reassemble the machine.
9.
Check if the serial number shows on the operation panel. (SP5-811-002). Input the
serial number if it does not show. (Contact your supervisor about this setting.)
10. Plug in the power cord. Then turn the main switch on.
11. Copy the data from the SD card to the NVRAM (
(SP5-846-52) if you have successfully copied them to the SD card.
The counter data in the user code information clears even if step 11 is done
correctly.
An error message shows if the download is incomplete. However, you can still
use the part of the address book data that has already been downloaded in
step 11.
An error message shows when the download data does not exist in the SD
card, or, if it is already deleted.
You cannot do this procedure if the SD card is write-protected.
12. Go out of SP mode. Then turn the main switch off. Then remove the SD card from the
SD card slot 3.
13. Turn the main switch on.
14. Specify the SP and UP mode settings.
15. Do ACC for the printer application program.
When installing a new NVRAM, refer to "When installing a new NVRAM".
When installing a new NVRAM
After installing a new NVRAM, do the following procedure.
1.
Enter the SP mode.
2.
Do the "NVRAM Download" with SP5-825-001 or input the settings while referring to
SM
SP5-824-001) and the address book data in the HDD
SP5-825-001) and HDD
3-115
Electrical Components
SP5-990-001) if possible.
G133
Advertisement
Chapters
Table of Contents
