Ricoh G133 Service Manual page 373

196 Area0: Y
197 Area1: Y
198 Area2: Y
199 Area3: Y
200 Area4: Y
201 Area5: Y
202 Area6: Y
203 Area7: Y
204 Area8: Y
205 Area9: Y
206 Area10: Y
207 Area11: Y
208 Area12: Y
[Area Shad. Correct. Setting] FA
Adjusts the area correction value for each LD power.
The main scan is divided into 16 areas. However, the image areas are limited
from area 1 to area 14.
2152
For BK and Magenta, area 1 is at the rear side of the machine (left side of the
image) and area 14 is at the front side of the machine (right side of the image).
For Cyan and Yellow, area 1 is at the front side of the machine (right side of the
image) and area 14 is at the rear side of the machine (left side of the image).
001 Area 0: Bk
002 Area 1: Bk
003 Area 2: Bk
SM
*ENG Not used
*ENG
*ENG
*ENG
*ENG
Adjusts the area magnification for LD 0.
[–256 to 255 / 0 / 1 sub-dot/step]
*ENG
*ENG
*ENG
*ENG
*ENG
*ENG
Not used
*ENG
*ENG
This is for the synchronizing detection
*ENG
board.
*ENG
[50 to 150 / 100 / 1 %/step]
*ENG
5-51
Service Mode Table
G133