Ricoh G133 Service Manual page 62

Punch Unit (B807)
14. Connect the harnesses [P] to the main PCB.
15. Put the harnesses [Q] through the hole [R] in the rear frame (
16. Install the punch drive motor [S] on the rear frame (
17. Connect the drive motor harness [T] (yellow connector) to the harness from the punch
unit ( x 1).
18. Connect the home position sensor harness [U] (yellow connector) from the punch unit
to the home position sensor [V].
19. Install the sub-scan registration sensor unit [W] from the rear side (
20. Route and connect the harnesses as shown (
G133
x 2).
x 2).
1-32
x 1).
x 2).
SM