Merging Selected Output Sources; Editing After Call - Compulite Spark User Manual

Merging selected output sources

Pressing the key associated with a specific output source calls the assignment to the editor.
More than one selection may be pressed in sequence. After collecting all the output, store
the result using the usual memory recording procedure
Use this function when you only want to Call some of the active playback devices.
Example: A three-color cyclorama wash is assigned to controllers 1 – 3. By combining the
3 colors at different levels, you create the desired color. . There are also active assignments
on A, and controllers 11 - 15. You want to record only the cyclorama wash, output from
controllers 1, 2, and 3, as memory 5.
Keypresses
1. Press [CALL]
2. Press the SK for controller 1
3. Press the SK for controller 2.
4. Press the SK for controller 3.
5. Press [=] [5] or [MEMORY] [5]
6. Press [STORE]

Editing after Call

All of the output merged in the editor is available for further editing. The editor is not
released after storing the memory.
Keypresses
1. Press [CALL]
2. Press [ENTER]
3. Select and modify chans/spots.
4. Press [=] [#]or [MEMORY] [#]
5. Press [STORE]
Using the Call Function
Results/Comments
The output from controller 1 is turned into
an editor group.
The output from controller 2 joins the editor
group.
The output from controller 3 joins the editor
group.
The merged output from controllers 1, 2,
and 3 are stored as memory 5. The editor is
retained.
Results/Comments
All active output is merged as an editor
group.
Set the system to memory record mode
and select a number.
The editor is not released.
7-13
Spark