Configuring The System For Midi; Configuring For Midi In Service Tools; Defining The Midi Channel In System Parameters - Compulite Spark User Manual

22-2

Configuring the System for MIDI

Configuring the System for MIDI
To configure Spark for MIDI communication, you must enable bit Q Sys in Service Tools/
Config Sys /Special Functions. You must also define the MIDI communication channel in
the System Parameters menu.

Configuring for MIDI in Service Tools

Keypresses
1. Go to Service Tools.
2. Press F3 Config Sys.
3. Enter the password.
4. Press F4 Special Functions
5. Press the arrow keys until the
cursor is on Bit Q MIDI
6. Press F1 Toggle
7. Press F6 Enter & Exit
8. Press F6 Store Configuration
9. Turn off Spark and switch it
back on.
10. Press F1 Cold Start

Defining the MIDI channel in System Parameters

Keypresses
1. Press MENU
2. Press 8 ENTER
3. Use the arrow keys to move the cursor,
highlighting MIDI i/o channel.
4. Press F1 Enter
5. Enter the MIDI communication channel
(1 - 16) on the numeric keypad.
6. Press F1 Store
Spark
Results/Comments
Bit Q is now toggled to Enable
The main Config Sys menu is displayed. A
confirmation request is displayed.
Spark now boots up. After major changes in
the system configuration it is necessary to
power down and power up again.
The system exits Service Tools and comes
up in editor mode.
Results/Comments
The menu list is displayed.
The System Parameters menu is
on view.