Programming Parts With Selected Parameters; Dividing A Memory Into Parts - Compulite Spark User Manual

Programming Parts with selected parameters

Specific spot parameters can be assigned Parts. Only parameters appearing in light or dark
red can be assigned parts.
Example: Assign parameter 6 of spots 1 - 5 to part 1.
Keypresses
Æ
1. Select spots 1
2. Select parameter 6 and
assign a value.
3. Press [PART] and enter 1 on
the numeric keypad.
4. Press [TIME] and enter 3 on
the numeric keypad.
5. Press [WAIT] and enter 2 on
the numeric keypad.
6. Press [=] and enter 1 on the
numeric keypad.
7. Press [STORE]

Dividing a Memory into Parts

Memories can be modified as Part Qs after they have been stored. This option works like
Basic Memory Modification and may be done live or in Blind mode.
Keypresses
1. Select memory 1
2. Select channels 1
3. Press [PART] and enter 1 on
the numeric keypad.
4. Press [TIME] and enter 3 on
the numeric keypad.
5. Press [WAIT] and enter 2 on
the numeric keypad.
6. Select channel 4
7. Press [PART] and enter 2 on
the numeric keypad.
8. Press [WAIT] and enter 8 on
the numeric keypad.
9. Press [STORE]
Dividing a Memory into Parts
Results/Comments
5.
Assign the selected parameter to part 1. A
green dash is displayed next to the selected
parameters.
Assign a fade of 3 counts to the selected
parameter in part 1.
Assign a wait time: the amount of time part 1
will wait before beginning its fade.
The message Memory 1 Stored is displayed.
Results/Comments
Æ
5. The channels and spots are displayed in dark
blue.
The intensity assignments of the selected
channels are displayed in green.
The intensity assignment of the selected
channel is displayed in gray.
Memory 1 is stored with the part assignments.
15-5
Spark