Client/Server Ip - Brocade Communications Systems WFT-2D User Manual

4
Software Configuration
4. Click Apply or OK to save your work.
5. Click OK on the "changes take effect after client restart" message.

Client/Server IP

You can configure connections between the client or switches and the Management application
server.
Configuring the server IP address
If your Operating System is IPv4-enabled or IPv6-enabled (running in dual mode), the server binds
using an IPv4 address. IPv6 only mode does not support server to client communication (the IPv6
address cannot be bound to the server).
NOTE
If the Management server or client has multiple Network Interface Cards and if any of these
interfaces are not plugged in, you must disable them; otherwise, the following features do not work
properly:
Server impact
•
•
•
•
•
Client impact
•
•
•
•
•
To configure the IP address used by the server for client-server communications, complete the
following steps.
1. Select Server > Options.
2. Select Client/Server IP in the Category list to set the IP address.
116
NOTE
Changes to this option take effect after a client restart.
Configuration wizard (does not display all IP addresses)
Trap and Syslog auto registration
Report content (Ipconfiguration element does not display all server IP addresses)
Network OS configuration backup through FTP
Trace dump through FTP
Options dialog box (does not display all IP addresses)
Firmware import and download dialog box
Firmware import for Fabric OS and Network OS products
FTP button in Technical Support Repository dialog box
Technical supportSave of Fabric OS, Network OS, and Host products through FTP
The Options dialog box displays.
The Client/Server IP pane displays (Figure 40).
Brocade Network Advisor SAN User Manual
53-1003154-01