33
MAPS actions
4. Click OK on the MAPS Policy Actions dialog box.
5. Click Close on the MAPS Configuration dialog box.
Configuring e-mail notification
In environments where it is critical that you are notified about errors quickly, you can use e-mail
notifications. With e-mail notifications, you can be notified of serious errors by e-mail, text
message, or pager, so you can react quickly.
1. Right-click a device in the Product List or Connectivity Map and select Fabric Vision > MAPS >
2. Select an object in the MAPS policies list and click E-mail Setup.
3. Enter one or more addresses in the E-mail address text box.
4. Enter the IP address of the relay host in the Relay Host field.
1350
•
Switch Status Critical — Use to set the switch status to critical
•
Switch Status Marginal. — Use to set the switch status to marginal.
For a complete list of categories and the associated measures and actions, refer to
categories, measures, and actions"
Configure.
The MAPS Configuration dialog box displays.
Select All Fabrics to configure e-mail notification for all policy rules for all MAPS-enabled
devices in all fabrics.
Select one or more fabrics to configure e-mail notification for all policy rules on all
MAPS-enabled devices in the selected fabrics.
Select one or more devices to configure e-mail notification for all policy rules on the selected
devices.
The MAPS E-Mail Setup dialog box displays. This dialog box enables you to configure e-mail
notification for all policy rules on a device.
You can enter up to 5 addresses, separated by semi-colons. E-mail addresses are logical
switch specific, not physical chassis specific. You can configure different e-mail addresses for
different logical switches in the same physical chassis.
To send a text message or page via e-mail, use the following format number@carrier.com,
where number is your phone number and carrier.com is the SMS server. For example,
3035551212@txt.att.net (text message) or 3035551212@page.att.net (page).
NOTE
Check with your carrier for the exact e-mail address.
Relay host is a physical chassis setting. This setting affects all logical switches in the physical
chassis.
on page 1335.
Brocade Network Advisor SAN User Manual
"MAPS
53-1003154-01