10.7 Settings In The Function - Konica Minolta bizhub 362 Service Manual

Field Service Ver. 1.0 Dec. 2008

10.7 Settings in the Function

10.7.1 F1
• To check the paper feeding in the paper take-up/transport sections without printing on
Functions
the paper with the engine unit.
Use • When a paper misfeed occurs.
1. From the Tech. Rep. Mode screen, touch [Function] → [F1] in that order.
2. Select the paper source, and then press the Start key.
Setting/
Touch [Duplex] to feed out the paper along the paper path for 2-sided copying.
Procedure
3. The sequence is halted when the Stop key is pressed or there is no paper.
These pages are not counted with the counters.
10.7.2 F2
• This test is for factory adjustment only and should NOT be used.
10.7.3 F7-1
Functions • To automatically adjust the Original Size Detecting Sensor.
• When the Original Size Detecting Sensor is replaced
Use
• When an optional sensor is mounted
1. From the Tech. Rep. Mode screen, touch [Function] → [F7-1] in that order.
Setting/
Procedure P.110
10.7.4 F7-2
Functions • To automatically adjust the Original Size Detecting Sensor. (only for a FAX)
• When the Original Size Detecting Sensor is replaced
Use
• When an optional sensor is mounted
Setting/ See P.35 of the FK-503 service manual.
Procedure
10.7.5 F8
Functions • To automatically adjust the ATDC sensor.
Use • When developer is replaced
1. From the Tech. Rep. Mode screen, touch [Function] → [F8] in that order.
2. Press the Start key to perform the ATDC sensor gain adjustment.
Setting/
• After the adjustment is finished, the operation stops automatically.
Procedure
• The adjusted setting overwrites the current setting for ATDC Sensor Gain in Printer of
Tech. Rep. Mode.
10. Tech. Rep. Mode
171