Initial Mode; Initial Mode Function Setting Procedure; Exiting; Initial Mode Function Tree - Konica Minolta bizhub 362 Service Manual

7. Initial Mode

7. Initial Mode
7.1

Initial Mode Function Setting Procedure

1. Press the Warm Restart switch, and "●" appears at the center on the left end of the
screen.
2. Enter "3" from the 10-Key Pad.
3. Type the 8-digit service code and touch [Enter]. (Default value: 00000000)
NOTE
• When [END] is touched after a wrong service code has been entered, the Basic
screen reappears.
• At the fourth access after entries of three wrong access codes, [END] is not avail-
able on the screen. It is therefore necessary to turn OFF and ON the Main Power
Switch.
• If you forget the service code, it becomes necessary to replace the RAMS Board
with a new one. Take necessary steps not to forget the service code.
• The RAMS Board is not available as a replacement part. If it requires replacement,
contact Office Printing Support Division by way of CSES.
4. Select a function.
7.1.1

Exiting

• Touch [Exit].
7.2

Initial Mode Function Tree

NOTE
• Of the Initial mode functions, only those related to the fax machine will be
described in the following.
• *1: If enhance security mode is set ON, menu is not shown.
Clear FAX Setting *1
26
Initial
Exit
Touch Panel
Total Clear
Adjustment
To t a l C o u n t e r
Marketing Area
C l e a r
Clear FAX
Image Data Clear
Setting
D a t a /
T i m e S e t t i n g
Trouble Reset
Initial Mode
Field Service Ver. 1.0 Dec. 2008
4040F3E565DA
Ref.
page
P.27