Finisher; Trail Erase (Dup); Internet Isw - Konica Minolta bizhub 362 Service Manual

10. Tech. Rep. Mode
10.3.7

Finisher

A. Punch Stop Position
Functions • To adjust the paper stop position for punching.
Use • To adjust the punch position.
Setting/ See P.32 of the FS-530/PU-501/OT-602 service manual.
Procedure
B. Punch Loop Adjustment
Functions • To adjust the length of the loop for correcting skew during punching.
Use • To correct any skew in the punch position.
Setting/ See P.33 of the FS-530/PU-501/OT-602 service manual.
Procedure
10.3.8

Trail Erase (Dup)

• To set the adjustment value for the amount of erase on the trailing edge for 2-sided
Functions
printing.
• The amount erased at the trailing edge of the second side of a 2-sided print is the Trail-
Use
ing setting for Edge Erase + Duplex Trailing Erase setting.
Setting/ • The default setting is "2 mm".
Procedure • The adjustment range is 0 to 5 mm.
10.3.9

Internet ISW

• By using this setting, the firmware stored in the server can be downloaded over internet
for upgrading.
• For details for upgrading the firmware, refer to "Firmware rewriting by the Internet ISW" in
the MAINTENANCE section.
See P.45
A. Login name
Functions
• To register the login name for accessing the program server where firmware is to be
stored.
Use
Setting/ 1. Select [Login name].
Procedure 2. Enter the login name (up to 64 one-byte characters) on the on-screen keyboard.
B. Password
Functions
• To register the password for accessing the program server where firmware is to be
stored.
Use
1. Select [New Password].
2. Enter the password (up to 64 characters) on the on-screen keyboard, and touch
[Enter].
Setting/
3. Select [Confirm New Password].
Procedure
4. Enter the password (up to 64 characters) on the on-screen keyboard again, and touch
[Enter].
5. Touch [Enter].
164
Field Service Ver. 1.0 Dec. 2008