Center Erase Width; Country Set; Orientation Change - Konica Minolta bizhub 362 Service Manual

Field Service Ver. 1.0 Dec. 2008
B. Zoom
• To set the scanning zoom ratio in the main and sub scanning directions of the Sheet-
Functions
through-ADF.
Use • Upon setup of the Automatic Document Feeder
Setting/ See P.18 of the DF-620 service manual.
Procedure
C. Feed (CD)
• To adjust the scan start position in the main scanning direction (CD) of the Sheet-
Functions
through-ADF.
Use • Upon setup of the Automatic Document Feeder
Setting/ See P.18 of the DF-620 service manual.
Procedure
D. Feed (FD)
• To adjust the scan start position in the sub scanning direction (FD) of the Sheet-
Functions
through-ADF.
Use • Upon setup of the Automatic Document Feeder
Setting/ See P.18 of the DF-620 service manual.
Procedure
10.3.4

Center Erase Width

Functions • To set the amount of center erase for bound originals.
Use • To change the amount of center erase for bound originals.
Setting/ • The default setting is "12 mm".
Procedure • The adjustment range is 2 to 20 mm.
10.3.5

Country Set

See P.33 of the FK-503 service manual.
10.3.6

Orientation Change

• To set whether or not to match the orientation of the image when paper is fed out
Functions
between the normal mode and Staple and Punch mode.
<ON>
• Turn ON the function if the orientation of the image when paper is fed out is matched
between the normal mode and Staple and Punch mode.
Use
<OFF>
• Turn OFF the function if the orientation of the image when paper is fed out is not
matched between the normal mode and Staple and Punch mode.
• The default setting is "OFF".
Setting/
Procedure
ON "OFF"
10. Tech. Rep. Mode
163