Canon iR1600 Series Service Manual page 710

CHAPTER 2 OPERATION
Setting the Network Interface Board
At time of shipment, the network interface board is set so that the speed of transmission
and transfer of 10BASE/100BASE is detected automatically.
If a fault occurs frequently in communication with the host machine on the LAN,
change the setting of the DIP switch.
Be sure to turn off the machine before changing the settings of the DIP
switch.
DIP SW
SW1
SW2
SW3
SW4
Full-Duplex Using a conversion hub, 2 points are selected for connection
Memo
Half-Duplex At any time, data may only be transmitted in one direction
2 - 6
COPYRIGHT © 2002 CANON INC.
SW
F02-103-01
Item
fixed to OFF
auto (ON)/fixed (OFF)
100 Mbps (ON)/10 Mbps (OFF)
full duplex (ON)/half-duplex (OFF) OFF
(nodes of the LAN) for simultaneous transmission and re-
ception of data packets.
for transmission or reception of data packets, i.e., transmis-
sion and reception cannot take place at the same time.
2001 2001 2001 2001
Default
OFF
ON
OFF
CANON Printer Board-N1/iN-E5 REV.0 MAR. 2002