Canon iR1600 Series Service Manual page 492

CHAPTER 13 TROUBLESHOOTING
No.
Function
62 wait time for reply from the server
(SMTP transmission)
63 wait time for reply from the server
(SMTP transmission)
64 wait time for reply from the server
(POP reception)
65 wait time for reply from the server
(FTP transmission)
66 communication time-out length
(SMTP transmission)
67 communication time-out length
(SMTP reception)
68 communication time-out length
(POP transmission)
69 communication time-out length
(FTP transmission)
70 number of text lines possible for
mail reception
[No. 02. 03, 04]
Use it to set conditions for RTN signal transmission. If an error occurs often when the
RTN signal is transmitted at time of reception, increase the parameters to loosen the RTN
signal transmission conditions.
The following error codes are associated with the transmission of the RTN
signal at time of reception:
Memo ##104, ##107, ##114, ##201
The RTN signal transmission condition (1) is the ratio of the number of
error lines in relation to the total number of lines per page of reception
images.
The RTN signal transmission condition (2) is the reference value
burst errors
The RTN signal transmission condition (3) is the number of errors not
reaching the reference value for burst errors.
*1: transmission errors spanning several lines.
*2: If set to '15', a transmission error spanning 5 consecutive lines is
If any of these conditions is detected while an image signal is being re-
vised, the RTN signal will be transmitted after receiving the procedure
signal from the transmitting machine. A higher parameter will make the
transmission of the RTN signal more difficult.
13-114
COPYRIGHT© 2002 CANON INC.
*1
.
identified as a burst error.
Range of settings
0 to 65535 sec
0 to 65535 sec
0 to 65535 sec
0 to 65535 sec
0 to 65535 min
0 to 65535 min
0 to 65535 min
0 to 65535 min
0 to 65535 lines
T05-504-03
2000 CANON iR1600/iR2000/iR1610/iR2010 SERIES REV.0 MAR. 2002
Initial Remarks
300
300
300
300
60
60
60
60
300
*2
for