Canon iR1600 Series Service Manual page 357

10) Connect the connector of the relay
cable [1] that comes with the kit to
J208 of the image processor PCB.
11) Secure the relay cable [1] in place using
the edge saddle [3] on the mounting
base [2].
12) Go through steps 5) through 9) in re-
verse to mount the multiport unit.
13) Secure two cables [2] in place using
the edge saddle [1] on the multiport
unit. Connect the connector [3] (J104)
to the G3 multiport PCB.
14) Mount the rear cover; thereafter, go to
step 16).
When installing the rear cover,
take care not to damage the re-
lay cable.
COPYRIGHT© 2002 CANON INC. 2000 CANON iR1600/iR2000/iR1610/iR2010 SERIES REV.0 MAR. 2002
CHAPTER 11 INSTALLATION
[1]
[3]
F11-703-07
[3] [1]
F11-703-08
[2]
[2]
11-43