Misfeed At Tray 5: Jam T5 - Xerox Phaser 6300 Service Manual

Misfeed at Tray 5: Jam T5

Paper being fed from the 1100-Sheet Feeder did not reach the Registration Sensor on
time.
Applicable Status Code:
Code 159: Feed Jam
Initial Actions:
Try picking paper from a different tray.
Ensure that Tray 5 is installed properly and the paper guides are set correctly.
Remove, fan, and reload supported media in Tray 5.
Remove any obstructions or debris in the paper path and cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Feed Rollers, PL12.5.18
Paper Pick Assembly, PL12.5.1
Drive Assembly, PL12.3.9
OPFDR2 Harness, PL12.3.7
OPTFDR Board, PL12.3.3
OPFREC2 Harness, PL12.3.1
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the printer paper path.
Does paper feed correctly from Tray 2?
2 If possible, print a Test print from Tray 5.
Does the Drive Assembly operate?
3 Test the Drive Assembly.
Run the Service Diagnostics HCF/LTA Motor
test.
Does the Drive Motor function correctly?
4
Check for +24 V to the Drive Motor.
1. Disconnect P/J82.
2. Close the Interlock Switch while testing.
Is the voltage between P82-1 <=> ground on
the Upper Circuit Board HCF +24 V?
Error Messages and Codes
Wiring and Plug/Jack References
1100-Sheet Feeder P/J Locator (page 10-10)
1100-Sheet Feeder Drive Wiring (page 10-30)
1100-Sheet Feeder Lower Tray Wiring (page 10-32)
Yes
Go to Step 2.
Go to Step 9.
Replace the
Engine Control
Board,
page 8-107.
Go to Step 7.
No
See "Misfeed at
Tray 2 Jam T2"
on page 3-20.
Go to Step 3.
Go to Step 4.
Go to Step 5.
3-29