Environmental Sensor Failure - Xerox Phaser 6300 Service Manual

Troubleshooting Procedure Table (Continued)
Step Actions and Questions
2 Replace the affected Toner Cartridge.
Does the error persist after a genuine
Xerox Toner Cartridge is installed?
3 Check the CRUM Reader connection.
Is P/J341 connected to the harness?
4 Replace the CRUM Reader.
Does the error persist?
5 Check all pins on the RFID2 Harness
PL7.2.16 for continuity.
1. Disconnect P/J341 and P/J3411.
2. Check continuity between J341 <=>
J3411.
6 Check all pins on the RFID Harness
PL7.2.17 for continuity.
1. Disconnect P/J3411 and P/J34.
2. Check continuity between P3411 <=>
J34.

Environmental Sensor Failure

An error was detected in the Environmental Sensor circuitry.
Applicable Status Code:
Code 102: Environmental Sensor Error
Troubleshooting Reference Table
Applicable Parts
Temp/Humidity Sensor, PL9.1.20
TMP Harness, PL10.1.4
Troubleshooting Procedure Table
Step Actions and Questions
1 Test the Temperature/Humidity Sensor.
Run the Service Diagnostics Temperature/
Humidity Sensor test.
Does the sensor function correctly?
3-78
Wiring and Plug/Jack References
Print Engine Map 4 - P/J Locator (page 10-8)
Print Engine Fuser Wiring (page 10-22)
Phaser 6300/6350 Color Laser Printer Service Manual
Yes
Go to Step 3.
Go to Step 4.
Go to Step 5.
Go to Step 6.
Replace the Engine
Control Board
(page 8-104).
Yes
Go to Step 2.
No
Complete
Connect the
CRUM Reader
Board
Complete
Replace the
RFID2 Harness.
Replace the RFID
Harness.
No
Replace the Temp/
Hum Sensor
(page 8-108).